SFP-10G-USR光模块产品简介

10/100/1000 Ports

SFP-10G-USR光模块 

All the 10/100/1000 ports use RJ-45 connectors and Ethernet pinouts.

 SFP-10G-USR光模块

Figure B-1 10/100/1000 Port Pinouts

 SFP-10G-USR光模块

10 Gigabit Ethernet CX1 (SFP+ Copper) Connectors

 SFP-10G-USR光模块

The 10-Gigabit Ethernet electrical modules use CX1 copper connectors similar to the one shown in Figure B-2

NoteWhen ordering or using CX1 cables, ensure that the version identifier is 2 or higher.

The 10-Gigabit Ethernet optical modules use the connectors shown in Figure B-3 and Figure B-4

Figure B-2 10-Gigabit Ethernet CX1 Copper Connector (example)

SFP Module Connectors

SFP-10G-USR光模块 

Figure B-3 Duplex LC Cable Connector

Figure B-4 Simplex LC Cable Connector

Figure B-5 Copper SFP Module RJ-45 Connector

SFP-10G-USR光模块 

10/100 Ethernet Management Port

The 10/100 Ethernet management port uses RJ-45 connectors with Ethernet pinouts. Figure B-6shows the pinouts.

 SFP-10G-USR光模块

Figure B-6 10/100 Port Pinouts

Console Port

 SFP-10G-USR光模块

The switch has two console ports: a USB 5-pin mini-Type B port on the front panel (Figure B-7 and an RJ-45 console port on the rear panel.

Figure B-7 USB Mini-Type B Port

The USB console port uses a USB Type A-to-5-pin mini-Type B cable (Figure B-8). The USB Type A-to-USB mini-Type B cable is not supplied. You can order an accessory kit (part number 800-33434) that has this cable.

Figure B-8 USB Type A-to-USB 5-Pin Mini-Type B Cable

The RJ-45 console port uses an 8-pin RJ-45 connector. The supplied RJ-45-to-DB-9 adapter cable connects the console port of the switch to a console PC. You need to provide a RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You can order that adapter (part number ACS-DSBUASYN=). Table B-2 and Table B-3 list the console port and adapter pinout information.

Cables and Adapters

•SFP Module Cables

•Cable Pinouts

•Console Port Adapter Pinouts

SFP Module Cables

Each port must match the wave-length specifications on the other end of the cable, and the cable must not exceed the stipulated cable length. Copper 1000BASE-T SFP module transceivers use standard four twisted-pair, Category 5 cable at lengths up to 328 feet (100 meters).