产品分类
联系我们
回收CISCO NM PA系列
首页 » 产品展示 » 网络模块接口卡回收 » 回收CISCO NM PA系列
PA-2FE-TX思科原装线卡模块产品简介
The PA-2FE provides two 10/100-Mbps, PA-2FE-TX思科原装线卡模块10/100BASE-T Fast Ethernet/Inter-Switch Link (ISL) interfaces and supports both full-duplex and half-duplex operation.Figure 1-1 PA-2FE-TX—Faceplate View
Figure 1-2 PA-2FE-FX—Faceplate View PA-2FE-TX思科原装线卡模块
Fast Ethernet Overview
The term Ethernet is commonly used PA-2FE-TX思科原装线卡模块for all carrier sense multiple access collision detect (CSMA/CD) LANs that generally conform to Ethernet specifications, including Fast Ethernet under IEEE 802.3u.
Note100BASE-TX is intended for Environment A, and 100BASE-FX PA-2FE-TX思科原装线卡模块is intended for Environment B. Both are described in the IEEE 802.3u standard.
IEEE 802.3u is well suited to applications where PA-2FE-TX思科原装线卡模块a local communication medium must carry sporadic, occasionally heavy traffic at peak data rates. Stations on a CSMA/CD LAN can access the network at any time. Before sending data, the station listens to the network to see if it is already in use. If it is in use, the station waits until the network is not in usePA-2FE-TX思科原装线卡模块, then transmits. This process is known as half-duplex operation. A collision occurs when two stations listen for network traffic, hear none, and transmit almost simultaneously. When simultaneous transmission occurs, both transmissions are damaged and the stations must retransmit. The stations detect the collision and use backoff algorithms to determine when they should retransmit.PA-2FE-TX思科原装线卡模块
Both Ethernet and IEEE 802.3u are broadcast networks, which means that all stations see all transmissions. Each station must examine received frames to determine whether it is the intended destination and, if it is, pass the frame to a higher protocol layer for processing.
IEEE 802.3u specifies the following different physical layers for 100BASE-T:
•100BASE-TX—100BASE-T, half- and full-duplex over Category 5 UTP, EIA/TIA-568-compliant cable
•100BASE-FX—100BASE-T, half- and full-duplex over optical fiber
Each physical layer protocol has a name that summarizes its characteristics in the format speed/signaling method/segment length, where speed is the LAN speed in megabits per second (Mbps), signaling method is the signaling method used (either baseband or broadband), and segment length is the maximum length PA-2FE-TX思科原装线卡模块between stations in hundreds of meters. Therefore, 100BASE-T specifies a 100-Mbps, baseband LAN with maximum network segments.
IEEE 802.3u 100BASE-T Specifications
This section provides specifications for PA-2FE-TX思科原装线卡模块IEEE 802.3u 100BASE-T. provides cabling specifications for 100BASE-TX Fast Ethernet transmission over UTP and foil twisted-pair (FTP), and 100BASE-FX Fast Ethernet over fiber-optic cables. It also summarizes IEEE 802.3u 100BASE-TX and 100BASE-FX physical characteristics.