NM-2V思科原装线卡模块产品简介

Cisco Voice Network NM-2V思科原装线卡模块Modules provide enterprises, managed service providers, and service providers the ability to directly connect the public switched telephone network (PSTN) and legacy telephony equipment to existing Cisco 2600, Cisco 3600, and Cisco 3700 routers. The NM-1V andNM-2V思科原装线卡模块 NM-2V carrier modules support Voice Interface Cards (VICs) to provide this connectivity.

Note: The NM-1V and NM-2V NM-2V思科原装线卡模块carrier modules do not support WAN Interface Cards (WICs), which are data-only interface cards. The "V" in the product name indicates that these are voice carrier modules. The WIC carrier module product numbers are NM-1W and NM-2W.NM-2V思科原装线卡模块

Prerequisites

Requirements NM-2V思科原装线卡模块

There are no specific requirements for this document.

Components Used NM-2V思科原装线卡模块

The information in this document is based on the following hardware versions:

• Cisco NM-1V One Voice/Fax Interface Card Slot Network Module (supports two voice calls)

• Cisco NM-2V Two Voice/Fax Interface Card Slot Network Module (supports four voice calls)

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Network Diagram

The following diagram illustrates the NM-2V carrier module.

Features

The following features are available with the components listed in this document:

• Voice/fax over IP

• Router-based, modular design

• High-performance digital signal processing (DSP) architecture

• Cisco IOS® quality of service (QoS) features: Resource Reservation Protocol (RSVP), weighted fair queuing (WFQ), fragmentation, and interleave

• Compliant with the H.323 standard for audio and videoconferencing

• Works with existing phone and fax equipment

• Voice features require a Cisco IOS Plus feature set

Feature support across the 2600, 3600, and 3700 VIC NM-1V and NM-2V includes the following:

• Foreign Exchange Office (FXO) answer supervision

• FXO disconnect supervision

• Cisco Echo Cancellation (ECAN)

• Connection trunk

• Connection private line, automatic ringdown (PLAR)

• Cisco Hoot and Holler

• Cisco Tool Command Language (TCL) Interactive Voice Response (IVR) Version 2.0

• Transparent Common Channel Signaling (T-CCS)

• Busyout (local voice busyout [LVBO] and advanced voice busyout [AVBO])

• Pulse dialing

• Inbound hookflash (Foreign Exchange Station [FXS])

• Outbound hookflash (FXO)

• Caller ID (FXS)

• Caller ID (FXO)1

• Cisco Fax Relay

• T.38 Fax Relay

• T.37 fax store and forward (S&F)

• Fax passthrough

• Modem passthrough

• Dual tone multifrequency (DTMF) relay